my diy break cue

took me a couple of hours this morning, should really have taken progress pics but got too carried away! basically I cut the old tip and ferrule off then cut a ring into the shaft with a Stanley blade then chiselled it down to the inside diameter of the new ferrule and fine tuned it with a file, I had to adjust it a couple of times and move the ferrule further down the shaft to match the diameter but I got there in the end! ... its definitely not a professional job but hopefully it will do the trick.

specs are roughly
55.75inch down from 57.5
16.5oz
bp 14.5
10.5mm fibre ferrule with phenolic tip (was 9.5)

my diy break cue